“Rua Honu” is a well-maintained Leopard 38 cruising catamaran. This is an owner's version and has never been chartered. She has just been put back in the water after multiple upgrades, a new starboard engine (86 hours), and routine maintenance items and is ready to cruise. Recent upgrades and repairs include:
2024
- Sail drives fully reconditioned including new seals and zincs
- New Vitrifrigo fridge/freezer
- Trampoline reconditioned (perimeter banding)
- Full, two-coat anti-fouling bottom prep & paint
- Bird protection at the mast
- Full rigging inspection
- Reconditioned water maker with new piping, parts, and filters
- Full lube service on sail drives, both engines and generator. New fuel filters
- Replaced pump & thru-hull valve for air conditioning
- Installed new helm wheel wrap
- Replaced shower drain pump.
- Replace trim for shower head
2023
- Replaced Yanmar 3YM30 starboard engine (only 58 hours)
- Replaced flush units for both heads
- New 2.5 hp Suzuki motor for tender
2022
- All new Raymarine electronic equipment: Radar dome & display, chart plotter/fishfinder & thru-hull transducer, autopilot, wind vane & transducer
- All new windows in saloon
- Sails & stack pack (mainsail cover) fully reconditioned as follows:
MAINSAIL
- New edgings at luff & leach
- Repair torn flap over end of batten pockets
- Replace tell-tales
- Restitch head webbings
JIB
- Restitch UV cover
- Repair luff tape at top & bottom
STACK PACK
- Replace all 3 zippers
- New head cap
- Repair foot rope
- Repair minor tears
- New Magnum charger/inverter unit
- Full, detailed rigging inspection
- replaced questionable standing & running rigging and lifeline parts
- All new rub rail (waterline and Bimini top)
- New stainless steel propane grill and replaced propane line and valve with new.
- Stripped & refinished mahogany BBQ counter and epoxy coated and added solid surface top
- Replaced 100 gal freshwater tank
- Replaced anchor rode with 250’ all galvanized chain
- Replaced 3 hatches
- Replaced both props
2021
- New tender
- New ProFurl roller-furler
- Replaced plumbing trim and plumbing at the galley sink
- Replaced two 30-amp shore power cords and a 50-amp splitter
- Replaced tender winch lift line
- Replaced anchor windless controller
- Replaced low and high-speed foot control switches for power winch